ClearOne Matrice num AEC 4 In Mic/Line AEC 8 Out Mic/Line VOip Dante

MIC/LINE INPUTS & OUTPUTS

• Inputs: Balanced audio inputs, 3.81mm Orange color Phoenix/Euroblock type male header, Push-on miniterminal block

• Outputs: Balanced audio outputs, 3.81mm Black color Phoenix/Euroblock type male header, Push-on miniterminal block

• Frequency Response: 20Hz – 22kHz @ +4dBu, +/- 0.5dBu

• EIN (Equivalent Input Noise): 20kHz BW, max gain, Rs = 150Ω, -126dBu

• THD + N (Total Harmonic Distortion + Noise):

• - 20Hz – 22kHz @ +4dBu, line level, 0.006%

• - 20Hz – 22kHz @ -56dBu, mic level, <0.04%

• Dynamic Range: 20Hz – 20kHz @ 0dB, >105dB

• Crosstalk (Mic/Line): Channel to Channel, stimulus at 20dBu to receptor at -56dBu, 1kHz, < -98dB

• Input Impedance: Balanced (line to ground), 2.2kΩ, 1%

• Nominal Input Level: Adjustable -56dB to 0dB, 7dB step coarse gain

• Maximum Input Level: -65dBu to 20dBu

• Phantom Power: 48V, Impedance 6.81kΩ

• Output Impedance: Balanced (line to ground), 95Ω, 1%

• Output Level: 0dBu (Nominal), 20dBu (Max), -40dBu (Selectable)

USB AUDIO

• Port Type: USB-B connector

• Audio: Digital Audio, 2 x 2 bidirectional channels

• Sample Rate: 48kHz

• Sample Bit Depth: 24-Bit

• Compatible: USB 2.0, USB 3.0

TELEPHONE

• Port Type: RJ11

• Frequency Response:

• - Mic/Line Input to Telephone Out: 250Hz – 3.4kHz , +/- 2dB, 4dBu

• - Telephone In to Mic/Line Out: 250Hz – 3.4kHz, +/- 2dB, -15dBu

• THD + N:

• - Mic/Line Input to Telephone Out: <0.1% @ 4dBu

• - Telephone In to Mic/Line Out: <0.3% @ -15dBu

• Dynamic Range:

• - Mic/Line Input to Telephone Out: >67dBu

• - Telephone In to Mic/Line Out: >87dBu

• REN: Ringer Equivalent Number 0.2

• Transhybrid Balance: 30dB (1kHz, all AC terminations)

VOIP

• Port Type: RJ-45, 10/100Mbps Ethernet Network, Auto

Negotiation

• Audio: 5 Lines

• Codec: G.711 uLaw, G.711 ALaw, G.722

ETHERNET

• Port Type: RJ-45, 10/100Mbps Ethernet Network, Auto Negotiation

• IP address: IPv4 (IPv6 upgradeable through future s/w, f/w upgrade)

DANTE™ AUDIO

• Port Type: RJ-45 Gigabit Ethernet connectors for Primary and Secondary Ports

• Audio: Digital Audio, 16 x 16 bidirectional channels

• Sample Rate: 48kHz / 96kHz

• Sample Bit Depth: 24-Bit

C-LINK EXPANSION BUS

• Ports Type: RJ-45 (Cat5e or Cat6)

• C-Link In & Out: Proprietary Expansion Bus

• Audio: 64 Expansion channels

• Cable: Solid core, factory terminated Cat 5e or 6 cable

• Distance: Up to 150’ (45M)

P-LINK PERIPHERAL BUS

• Ports Type: RJ-45 (Cat5e or Cat6)

• P-Link In & Out: Proprietary Peripheral Bus

• PoE In:

• - P-Link In Port

• - PoE 802.3af Mode B, Midspan

• - Power on “spare pairs” 4,5 and 7,8

• - Input voltage range: 48V to 56V

• Audio: Up to 3 BMA CT units + up to 3 DIALOG 20

Wireless Receiver units + Up to 3 USB Expander units

+ Up to 3 GPIO Expander units

• Cable: Solid core, factory terminated Cat 5e or 6 cable

• Distance: Up to 200’ (60M)

• Long Distance P-Link:

• - Increases P-Link distance from 200 Ft to 650 Ft

• 650 Ft (200M) maximum cable distance between any two units

• - Cat6, 550 MHz, 23 AWG, solid conductor cable

• - Do not use Copper Clad Aluminum (CCA) cable

• - Available only for BFM2 peripheral units

• - 48V PoE Midspan Mode B power injector for 1 BFM2 unit

• - 56V PoE Midspan Mode B power injector for 3 BFM2 units

RS232

• Port Type: DB9 Female

• Settings: 9600/19200/38400/57600/115200 Baud;

Serial Echo; Flow Control

• Support: Serial commands

GPIO

• Port Type: 5.08mm Green color Phoenix/Euroblock

type male header

• Support: Control, Status, Variable Voltage Control

• Power Pin: 5V DC @ 350mA Power Source

• Pin 1 to 4:

• - Open Collector Outputs: 40VDC @ 250mA

• - Active Outputs (Source/Sink): 5VDC @25mA

• - Logic Inputs: 40.2kΩ pull up

• - Variable Voltage Control Inputs: 5VDC max

• Ground Pin: GND

USB CONTROL

• Port Type: USB-B connector

• Location: Front Panel

• Compatible: USB 2.0, USB 3.0

LEDs

• Location: Front Panel

• Status LED:

• - Off: Unit still initializing

• - Blue - Fast Blinking: Stack Syncing in progress

• - Blue - Slow Blinking: Unit not configured

• - Blue - Solid: Configured unit

• - Red - Fast Blinking: Stack Sync error

• Locate LED: Blue - Blinking: Unit “Locate” command received

• Power LED: Blue - Solid: Unit is powered on

TOUCH SENSOR

• Sensor Type: Capacitive Touch Button

• Location: Front Panel

POWER & THERMAL

• Port Type: AC Inlet

• Mains Voltage: 100-240V AC, 50/60Hz

• Power Consumption: 50 Watts Typical

• Thermal: 170 BTU/Hr Typical

• Operating Temperature: 14°F (-10°C) to 104°F (40°C) Ambient Temperature

DIMENSION & WEIGHT

• RU size: 1 RU

• Width x Depth x Height:

• 1. Without rack-ears: 17”W x 10.73”D x 1.72”H (43.2cmW

x 27.3cmD x 4.4cmH)

• 2. With rack-ears: 19”W x 10.73”D x 1.72”H (48.3cmW x

27.3cmD x 4.4cmH)

• Unit Weight: 9.3 lbs (4.2 kg) (Approximately)

• Shipping Weight: 13.8 lbs (6.3 kg) (Approximately)